Hebei Wotu Fastener Manufacturing Co., Ltd. would like to discuss the following six issues to pay attention to when using and maintaining self-drilling screws.
Today, Hebei Wotu Fastener Manufacturing Co., Ltd. will discuss the following six issues to pay attention to when using and maintaining self-drilling screws, hoping to provide significant assistance to everyone.
1. The rinsing process for self-drilling screws is very important and requires great care. Residue may remain on the surface of the screws during this process. Rinsing should be done after cleaning with a silicate cleaning agent.
2. Self-drilling screws must be stacked properly during tempering heating; otherwise, slight oxidation may occur in the quenching oil.
3. The appearance of white phosphide residue on the surface of high-strength screws indicates (point 1) insufficient attention to detail during inspection.
4. Blackening of the component surface due to chemical reaction indicates that the heat treatment was not thorough, and alkaline residues on the surface were not completely removed. 5. Standard parts may rust during rinsing, so the rinsing water should be changed frequently.
6. Excessive rust indicates that the quenching oil has been used for too long and needs to be added or replaced.
The above six points are summarized by our self-drilling screw manufacturer. We welcome any different opinions from you, and we will make changes and additions as needed to ensure better use. Finally, please remember that we are a self-drilling screw manufacturer in Yongnian. If you need self-drilling screws, please contact Wotu Fasteners!
For an M10–M24 U-bolt RFQ, buyers should send a dimensioned drawing that defines thread diameter, inside width, leg or overall length, bend geometry, thread length, application diameter, material or grade requirement, surface finish, matching nuts/washers, quantity, and packing needs. Nominal thread size alone is not enough because different measurement datums can produce U-bolts that look […]
When ordering L-shaped anchor bolts against an older standard, buyers should verify the standard’s current status, confirm the specification approved for the project, and reconcile the drawing, dimensions, material and foundation interface before releasing the purchase order. A legacy standard number on a product page or old drawing is not, by itself, sufficient evidence that […]
